Abamectin 0.15 Select Insecticide

DoMyOwn · Abamectin 2.0% · EPA Reg 83100-5-89442 · Insecticide Document last checked 2026-05-30

About this product

Active ingredient Abamectin 2.0%

Manufacturer DoMyOwn

Category Insecticide

Full details for Abamectin 0.15 Select Insecticide

Source product label ↗ Open the catalog source label while the local copy is reviewed. Verify the product name, EPA registration number, and revision before use. Source safety data sheet ↗ Open the catalog source SDS while the local copy is reviewed. Verify the exact product and revision before relying on it. EPA registration data Reg. 83100-5-89442 — registry reference, signal word and status.

Applicator discussion

Nothing here is label direction — the label is the law. These are notes from other applicators, moderated before they appear. Check the labeling accompanying the product and applicable state requirements.

Add your experience

Sign in through the portal or Create a free account to post. Comments are reviewed before they appear. Need a website for your pest-control business? See site plans.

According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 83100-5-89442 →

Abamectin 0.15 Select is an ornamental miticide and insecticide containing 0.15% abamectin. It is designed for the control of leafminers and mites (such as European Red Mite, Two-spotted Spider Mite, and Tarsonemid mites) and the suppression of aphids, whiteflies, and thrips on ornamental plants. It can also be used to prevent pine wilt nematode in non-crop bearing trees and woody shrubs. This product is an emulsifiable concentrate that can be applied via foliar spray or through injection into trees and shrubs. For foliar applications, it is used in nurseries, greenhouses, and both interior and exterior landscapes. When using foliar sprays, the label recommends repeating applications at 7-day intervals as necessary to maintain control. For injection, it is suitable for commercial forestry production, nurseries, and residential areas. Users should be aware of potential phytotoxicity, particularly on certain fern species like Adiantum and Shasta Daisy. Always follow specific directions for mixing and application rates based on the target pest and site.

Pests covered (5)

LeafminersMites (various species)Aphids, Thrips, and WhitefliesPine wilt nematodeAphids, Mites, Thrips

Areas treatable (2)

Ornamental PlantsNon-crop bearing trees and woody shrubs

How to treat each type of area 4

Ornamental Plants

Target pest	Location	Rate	Unit	Label notes
Leafminers	Outdoor	8 fl. oz.	per 100 gals.	Repeat at 7-day intervals as necessary to maintain control.
Mites (various species)	Outdoor	4 fl. oz.	per 100 gals.	For Tarsonemid mites, repeat applications to newly developing tissue.
Aphids, Thrips, and Whiteflies	Outdoor	8 fl. oz.	per 100 gals.	For suppression of pest populations; young immatures must be contacted by the spray.

Non-crop bearing trees and woody shrubs

Used via injection.

Target pest: Pine wilt nematode
Location: Outdoor

Mixing instructions 3

For pests	Location	Amount	Per	Finished strength
Leafminers	Foliar	8	fl. oz.	per 100 gals.
Mites	Foliar	4	fl. oz.	per 100 gals.
Aphids, Thrips, Whiteflies	Foliar	8	fl. oz.	per 100 gals.

Worker safety

Re-entry interval (REI) 12

PPE required Coveralls over short-sleeved shirt and short pants; Chemical-resistant gloves (EPA category B, e.g., barrier laminate or butyl rubber ≥ 14 mils); Chemical-resistant footwear plus socks; Protective eyewear; Chemical-resistant headgear for overhead exposure; For shadehouse/greenhouse use, a NIOSH-approved particulate facepiece respirator with any R or P filter or a NIOSH-approved elastomeric particulate respirator with any R or P filter; or a NIOSH-approved powered air purifying respirator with HE filters.

Timing & weather

Do not apply during temperature inversions.
Do not apply when wind speeds exceed 15 mph.
Avoid applications during gusty wind conditions.
Apply in calm weather when rain is not predicted for the next 24 hours.

Use restrictions 5

Do not apply to areas where surface water is present or to intertidal areas below mean high water mark.
Do not contaminate water when disposing of equipment wash water or rinsate.
Highly toxic to bees; do not apply to blooming crops or weeds being visited by bees.
Do not use in citrus nurseries.
Do not apply through any type of irrigation system.